From 01654bdec1f37a36be00b44c149aca2862eca60b Mon Sep 17 00:00:00 2001 From: Scott Lahteine Date: Fri, 10 Apr 2015 15:03:41 -0700 Subject: [PATCH] Cleanup formatting of some M codes --- Documentation/GCodes.md | 11 ++++------- 1 file changed, 4 insertions(+), 7 deletions(-) diff --git a/Documentation/GCodes.md b/Documentation/GCodes.md index 94756f8d9b..f7813830db 100644 --- a/Documentation/GCodes.md +++ b/Documentation/GCodes.md @@ -73,7 +73,7 @@ M140 - Set bed target temp M150 - Set BlinkM Color Output R: Red<0-255> U(!): Green<0-255> B: Blue<0-255> over i2c, G for green does not work. M190 - Sxxx Wait for bed current temp to reach target temp. Waits only when heating Rxxx Wait for bed current temp to reach target temp. Waits when heating and cooling -M200 D- set filament diameter and set E axis units to cubic millimeters (use S0 to set back to millimeters). +M200 - set filament diameter and set E axis units to cubic millimeters (use S0 to set back to millimeters).: D- M201 - Set max acceleration in units/s^2 for print moves (M201 X1000 Y1000) M202 - Set max acceleration in units/s^2 for travel moves (M202 X1000 Y1000) Unused in Marlin!! M203 - Set maximum feedrate that your machine can sustain (M203 X200 Y200 Z300 E10000) in mm/sec @@ -84,9 +84,9 @@ M207 - Set retract length S[positive mm] F[feedrate mm/min] Z[additional zlift/h M208 - Set recover=unretract length S[positive mm surplus to the M207 S*] F[feedrate mm/sec] M209 - S<1=true/0=false> enable automatic retract detect if the slicer did not support G10/11: every normal extrude-only move will be classified as retract depending on the direction. M218 - Set hotend offset (in mm): T X Y -M220 S- set speed factor override percentage -M221 S- set extrude factor override percentage -M226 P S- Wait until the specified pin reaches the state required +M220 - Set speed factor override percentage: S +M221 - Set extrude factor override percentage: S +M226 - Wait until the specified pin reaches the state required: P S M240 - Trigger a camera to take a photograph M250 - Set LCD contrast C (value 0..63) M280 - Set servo position absolute. P: servo index, S: angle or microseconds @@ -117,9 +117,6 @@ M907 - Set digital trimpot motor current using axis codes. M908 - Control digital trimpot directly. M350 - Set microstepping mode. M351 - Toggle MS1 MS2 pins directly. - -M928 - Start SD logging (M928 filename.g) - ended by M29 -M999 - Restart after being stopped by error ``` ## SCARA-specific M-Codes - May change to suit future G-code standards ```