From 69999f962a7783f0a79c4fc87b62caaf07d93187 Mon Sep 17 00:00:00 2001 From: Scott Lahteine Date: Mon, 14 Dec 2020 21:27:05 -0600 Subject: [PATCH] Please install the EditorConfig plugin --- Marlin/Configuration.h | 4 ++-- Marlin/src/pins/stm32f1/pins_CREALITY_V4.h | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h index 4b3371226e..8b29a4ba80 100644 --- a/Marlin/Configuration.h +++ b/Marlin/Configuration.h @@ -957,14 +957,14 @@ * X and Y offset * Use a caliper or ruler to measure the distance from the tip of * the Nozzle to the center-point of the Probe in the X and Y axes. - * + * * Z offset * - For the Z offset use your best known value and adjust at runtime. * - Common probes trigger below the nozzle and have negative values for Z offset. * - Probes triggering above the nozzle height are uncommon but do exist. When using * probes such as this, carefully set Z_CLEARANCE_DEPLOY_PROBE and Z_CLEARANCE_BETWEEN_PROBES * to avoid collisions during probing. - * + * * Tune and Adjust * - Probe Offsets can be tuned at runtime with 'M851', LCD menus, babystepping, etc. * - PROBE_OFFSET_WIZARD (configuration_adv.h) can be used for setting the Z offset. diff --git a/Marlin/src/pins/stm32f1/pins_CREALITY_V4.h b/Marlin/src/pins/stm32f1/pins_CREALITY_V4.h index 69371f0f73..8b5b8562a2 100644 --- a/Marlin/src/pins/stm32f1/pins_CREALITY_V4.h +++ b/Marlin/src/pins/stm32f1/pins_CREALITY_V4.h @@ -60,7 +60,7 @@ // #ifndef HAS_PIN_27_BOARD #define SERVO0_PIN PB0 // BLTouch OUT -#else +#else #define SERVO0_PIN PC6 #endif