Scott Lahteine
eb85342fd9
Merge pull request #2989 from AnHardt/fix2661
...
Pre home display - Stepper release
2016-03-05 21:30:17 -08:00
Scott Lahteine
772460a7b8
Various minor spelling corrections
...
Redo of #2939 rebased against RCBugFix
2016-03-05 20:41:15 -08:00
AnHardt
615bec2329
Activate warning about possible reduced accuracy by default
...
Renamed `WARN_REDUCED_ACCURACY` to `DISABLE_REDUCED_ACCURACY_WARNING`
Changed the condition for blinking from
```
#if ENABLED(WARN_REDUCED_ACCURACY)
```
to
```
#if DISABLED(DISABLE_REDUCED_ACCURACY_WARNING)
```
2016-02-28 23:20:21 +01:00
AnHardt
4b02f33e69
Distribute config-changes to the other configurations
2016-02-28 23:20:04 +01:00
Scott Lahteine
c2e5c6c12c
Nest Manual Bed Leveling options
...
This formalizes the dependency of MANUAL_BED_LEVELING on
MESH_BED_LEVELING
2016-02-20 20:35:10 -08:00
Scott Lahteine
b19b272172
Update configurations with SPI_SPEED
...
- Include aligned comment about new SDSUPPORT behavior
2016-02-17 14:54:09 -08:00
Scott Lahteine
159ff94afd
Remove obsolete HEATER_BED_DUTY_CYCLE_DIVIDER #2977
2016-02-07 08:02:11 -06:00
Ruwan J Egoda Gamage
b58083b0fa
Getting rid of SDEXTRASLOW, SDSLOW variables.
2016-02-07 07:58:52 -06:00
Ruwan J Egoda Gamage
1b7c443628
Adding SDULTRASLOW variable.
...
Instead of changing SDEXTRASLOW variable to a slower speed, the new
SDULTRASLOW is used for rigidbot panel.
2016-02-07 07:58:52 -06:00
Richard Wackerbarth
0b429461d5
Back port Cosmetic changes
2015-12-10 07:20:52 -06:00
Richard Wackerbarth
e7b40bbe98
Change link to U8glib source
2015-12-10 06:33:29 -06:00
Scott Lahteine
9b23490f01
Clean up spacing in configs
2015-11-12 00:03:21 -06:00
KiteLab
0ad25c6665
Hint for changed behaviour of SDSUPPORT
2015-09-28 11:07:33 -05:00
Richard Wackerbarth
e01f5e1ef7
Cleanup
2015-09-17 10:44:23 -05:00
Mike Cochrane
5e36b64635
SDEXTRASLOW for some SD card readers (PR#176)
...
Add SDEXTRASLOW which runs the SD card at SPI_QUARTER_SPEED. Quarter speed is needed for RIGIDBOT_PANEL
2015-09-14 07:58:08 -05:00
Richard Marko
91fd66ffba
add Lulzbot TAZ4 example configuration (PR#104)
2015-08-27 08:36:43 -05:00
