7188ce0ad6
Why double touch probing is not a good thing. It's widely believed we can get better __probing__ results when using a double touch when probing. Let's compare to double touch __homing__. Or better let's begin with single touch __homing__. We home to find out out position, so our position is unknown. To find the endstop we have to move into the direction of the endstop. The maximum way we have to move is a bit longer than the axis length. When we arrive at the endstop - when it triggers, the stepper pulses are stopped immediately. It's a sudden stop. No smooth deacceleration is possible. Depending on the speed and the moving mass we lose steps here. Only if we approached slow enough (below jerk speed?) we will not lose steps. Moving a complete axis length, that slow, takes for ever. To speed up homing, we now make the first approach faster, get a guess about our position, back up a bit and make a second slower approach to get a exact result without losing steps. What we do in double touch probing is the same. But the difference here is: a. we already know where we are b. if the first approach is to fast we will lose steps here to. But this time there is no second approach to set the position to 0. We are measuring only. The lost steps are permanent until we home the next time. So if you experienced permanently rising values in M48 you now know why. (Too fast, suddenly stopped, first approach) What can we do to improve probing? We can use the information about our current position. We can make a really fast, but deaccelerated, move to a place we know it is a bit before the trigger point. And then move the rest of the way really slow. |
||
|---|---|---|
| .. | ||
| Dual-head | ||
| Configuration.h | ||
| Configuration_adv.h | ||
| README.md | ||
Configuration for Velleman K8400 Vertex
Configuration files for the K8400, ported upstream from the official Velleman firmware. Like it's predecessor, (K8200), the K8400 is a 3Drag clone. There are some minor differences, documented in pins_K8400.h.
Single and dual head configurations provided. Copy the correct Configuration.h and Configuration_adv.h to the /Marlin/ directory.
NOTE: This configuration includes the community sourced feed rate fix. Use 100% feed rate in Repetier!
For implementation and updated K8400 firmware, see https://github.com/birkett/Velleman-K8400-Firmware
Original Sources
Credit to Velleman for the original 1.0.x based code:
http://www.vertex3dprinter.eu/downloads/files/vertex/firmware/vertex-m1-v1.4-h2.zip